I was using my Voodoo Lab Amp Switcher for a trial run on a new set-up I'd like to use live for smaller clubs. (I have a vintage BF Deluxe Reverb (OH/65), and a '69 Drip Edge Princeton)

Anyway.....I hooked up the amps, and was tweaking the settings (everything was working fine at this point), when all of the sudden the switcher made a horrendous noise, like a police siren wailing from a high pitch to low. I immediately disconnected the amps, and powered down the switcher.

Now...it lights up like it should, and can be programmed for running in solo or blended modes (in other-words, all the indicator lights function properly), but no signal passes into the amps. I've checked all my cables, volumes for each of the 4 channels, all inputs and outputs.....yet I get nothing.

Any ideas out there of what could have happened?

Cheers!

That is certainly strange... are the Ground Lift switches all in the Up position? Were you using the supplied power adapter with the Amp Selector?

I was using a dedicated iSpot, with nothing else hooked up to it. It's the second time I've had an "output" issue with this switcher, but I just dropped it off with Ben at the shop (thankfully I live near Santa Rosa), and he's going to hook me up!

BTW...the guys in the shop were having fun with the new Strymon Timeline. I got mine last week...and it's one of the most fun Delay's I've had the pleasure of using!

Thanks!