It is currently Tue Jan 23, 2018 9:02 am

All times are UTC - 8 hours [ DST ]





Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Pedal question
PostPosted: Fri Dec 22, 2017 8:01 am 
Offline

Joined: Fri Dec 22, 2017 7:50 am
Posts: 1
I run my ocd with a y jack which uses two 9 volt outlets.
This is to give the pedal higher output. Would using
A single 400 ma outlet be equivalent?


Top
 Profile  
 
 Post subject: Re: Pedal question
PostPosted: Fri Dec 22, 2017 10:45 am 
Offline

Joined: Tue May 05, 2009 2:33 pm
Posts: 6818
Location: The Lab
The OCD doesn't require higher current so there would be no benefit (or harm) in using a 400mA output.

However, the OCD will accept 9-18V so it can be powered directly from any 9V Output, any 12V Output, or with a Voltage Doubler Adapter connected to any two 9V Outputs.

I assume you have the Voltage Doubler with all black ends for 18V operation.
If you actually have the Current Doubler (the one with the Green end) then you can get rid of it since you don't need to use it with the OCD.

I hope that helps!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: