Current Doubler on the Pedal Power 4x4

General discussion and tech talk about the industry standard Pedal Power line of power supplies.
Post Reply
Joris
Posts: 2
Joined: Thu Aug 10, 2017 2:38 pm

Current Doubler on the Pedal Power 4x4

Post by Joris » Fri Oct 20, 2017 10:48 am

I have a Kingsley Page and Harlot ...each need 800mA 9V.
Can I use 2 current doublers on 1 4x4 power block ( on the 4 high current outputs 9V, 400mA)
Thx !

JohnClark
Posts: 7133
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: Current Doubler on the Pedal Power 4x4

Post by JohnClark » Fri Oct 20, 2017 11:58 am

The actual current draw for each of these pedals is under 500mA. You can use one 9V High Current output combined with any other 9V Output using a Current Doubler Adapter (the one with the Green end) on a 4x4 to power each one. No problem running two at the same time... in fact you could run four of them if you wanted ;)

I hope that helps!

Joris
Posts: 2
Joined: Thu Aug 10, 2017 2:38 pm

Re: Current Doubler on the Pedal Power 4x4

Post by Joris » Fri Oct 20, 2017 2:26 pm

JohnClark wrote:The actual current draw for each of these pedals is under 500mA. You can use one 9V High Current output combined with any other 9V Output using a Current Doubler Adapter (the one with the Green end) on a 4x4 to power each one. No problem running two at the same time... in fact you could run four of them if you wanted ;)

I hope that helps!
very helpful indeed !
Thank you.
Joris, Belgium

Post Reply