General discussion and tech talk about the industry standard Pedal Power line of power supplies.
2 posts • Page 1 of 1
I have a radial tonebone classic that runs on a 15vdc supply. What is the best way to power this pedal if at all with the PP2? Can I use output 5 or 6 with the dip switch on? Or could I get a Y-adapter and run use outputs 7 and 8 with them adjusted at 7.5 volts each using the dip switch on function?
The Tonebone Classic can not be powered from the front panel outputs. The documentation states that it requires 15V @ 400mA! You can run it from the Courtesy Outlet on the back of the Pedal Power 2 using the supplied adapter.