It is currently Thu Oct 30, 2014 5:53 am

All times are UTC - 8 hours [ DST ]





Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Earthquaker Devices Disaster Transport + PP2
PostPosted: Fri Feb 03, 2012 1:40 pm 
Offline

Joined: Fri Feb 03, 2012 1:31 pm
Posts: 1
I have been using for a while a PP2 and today I received the Earthquaker Devices Disaster Transport delay pedal. The power requirement of this pedal is 9v with a negative center. The matter is that I already used the 1-5 outputs. Is it fine to use the #7 or #8 outputs to power this pedal? It's a digital delay and I don't intend to use the SAG properties. Thanks in advance.


Top
 Profile  
 
 Post subject: Re: Earthquaker Devices Disaster Transport + PP2
PostPosted: Tue Feb 07, 2012 1:04 pm 
Offline

Joined: Tue May 05, 2009 2:33 pm
Posts: 4301
Location: The Lab
I don't see a current rating for this pedal, but you can certainly try it in any output with the corresponding DIP switch set to Normal. If it draws more than 100mA then you will have to power it from either output 5 or 6 with the DIP switch set to Normal.

I hope that helps!

_________________
Image
Voodoo Lab ®
Magician/Tech


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: