|
It is currently Wed May 22, 2013 7:39 pm
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
artmx47
|
Post subject: Earthquaker Devices Disaster Transport + PP2  Posted: Fri Feb 03, 2012 1:40 pm |
|
Joined: Fri Feb 03, 2012 1:31 pm
Posts: 1
|
|
I have been using for a while a PP2 and today I received the Earthquaker Devices Disaster Transport delay pedal. The power requirement of this pedal is 9v with a negative center. The matter is that I already used the 1-5 outputs. Is it fine to use the #7 or #8 outputs to power this pedal? It's a digital delay and I don't intend to use the SAG properties. Thanks in advance.
|
|
| Top |
|
 |
|
JohnClark
|
Post subject: Re: Earthquaker Devices Disaster Transport + PP2 Posted: Tue Feb 07, 2012 1:04 pm |
|
Joined: Tue May 05, 2009 2:33 pm
Posts: 3588
Location: The Lab
|
|
I don't see a current rating for this pedal, but you can certainly try it in any output with the corresponding DIP switch set to Normal. If it draws more than 100mA then you will have to power it from either output 5 or 6 with the DIP switch set to Normal.
I hope that helps!
_________________
Voodoo Lab ®
Tech/Magician
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: Bing [Bot] and 4 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
