line 6 pod pro xt

Q & A for building and interfacing your rack gear with Ground Control Pro and GCX-based systems.
Post Reply
felipe_esp
Posts: 21
Joined: Thu Aug 27, 2015 4:57 pm

line 6 pod pro xt

Post by felipe_esp » Thu May 10, 2018 9:21 am

hi guys: i´m having problems with my pod pro xt, i can´t get a right sound out of it, maybe i´m not setting this up ok, not sure even looking into the users guide of my pod which is the right input or output to use.
the loop goes like this:

ada mp1
G major
pod pro xt

each one of these goes to the gcx, then into the marshall el34 50/50

thank you!!

JohnClark
Posts: 7037
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: line 6 pod pro xt

Post by JohnClark » Thu May 10, 2018 12:16 pm

Judging from a picture of the back panel I'd say you would want to use the Line Level Input, and one of the Unbalanced Analog Out jacks. You may need to change some settings in the POD to get the Line in to work and to disable any Speaker Simulation.

I hope that helps!

felipe_esp
Posts: 21
Joined: Thu Aug 27, 2015 4:57 pm

Re: line 6 pod pro xt

Post by felipe_esp » Thu May 10, 2018 12:57 pm

JohnClark wrote:Judging from a picture of the back panel I'd say you would want to use the Line Level Input, and one of the Unbalanced Analog Out jacks. You may need to change some settings in the POD to get the Line in to work and to disable any Speaker Simulation.

I hope that helps!

thank you so much.
i´ll look into it.
greetings from Chile.

Post Reply