Page 1 of 1

Stiff 90-AD amp channel switching & effects loop on/off

Posted: Mon Feb 05, 2018 10:44 am
by Hamer95USA
Hello Voodoo Lab,

I have a Zoom G9.2tt floor processor and a Voodoo Lab control switcher. I recently bought a Stiff 90-AD amp head and would like to switch the amp channels between clean & overdrive and the effects loop on/off. The stock footswitch uses a stereo cable to allow for switching. My MIDI signal path is Zoom MIDI out > Voodoo Lab Control Switcher MIDI input.

Would I be able to use the stereo cable with the Control Switcher to switch amp channels and turn the effects loop on/off or would I need a 1/4" TRS male jack to TS male Y cable to access the amp's channel switching and effects loop on/off functions? Would I need to have a custom DIN cable built for me from Voodoo Labs? Your information would be greatly appreciated.

Re: Stiff 90-AD amp channel switching & effects loop on/off

Posted: Mon Feb 05, 2018 1:50 pm
by JohnClark
For that amp you would need an Insert Point cable. (One TRS end that breaks out to Two TS ends.)

I hope that helps!

Re: Stiff 90-AD amp channel switching & effects loop on/off

Posted: Mon Feb 05, 2018 10:22 pm
by Hamer95USA
Thanks for replying to my thread in a timely manner and the useful advice. I appreciate your technical information on this forum.

Guitar George