Multii amp switching with a GCX

Q & A for building and interfacing your rack gear with Ground Control Pro and GCX-based systems.
Post Reply
Posts: 15
Joined: Fri Sep 29, 2017 10:40 am

Multii amp switching with a GCX

Post by mindbenderzzz » Sat Feb 03, 2018 3:22 pm

So I am trying to do a multi preamp setup into a GCX and most of the wiring diagrams I see are a little confusing
I’m trying to do a 3 preamp mono setup is there a kind soul that could make a simple diagram for the most basic way to set this up.

I will have 3 preamps (1 is not here yet but will be soon)
And a power amp and a speaker cabinet
Several different patch cables in many sizes

Am I missing anything

For the record the setup will include
1 Alembic F2B preamp
1 Sarno preamp
1 unpowered Kemper Profiler which is bassicly a preamp)

1 VHT power amp
1 Hitone 4x12 speaker cab

Thanks in advance for anyone that has the answers I need

Posts: 7164
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: Multii amp switching with a GCX

Post by JohnClark » Mon Feb 05, 2018 1:39 pm

Here is a diagram that has Loops 1 and 2 being used to switch between three mono preamps... ... werAmp.pdf

The Output of Loop 2 would simply go to an Input on your power amp in your setup.

Let us know if you get stuck!

Post Reply