Voodoo Lab
http://www.voodoolab.com/forum/

Px plus general set up before programming
http://www.voodoolab.com/forum/viewtopic.php?f=9&t=8698
Page 1 of 1

Author:  Boneguitar [ Thu Dec 28, 2017 4:35 am ]
Post subject:  Px plus general set up before programming

Good morning voodoo lab forum,

I need advice or help. Just purchased the px plus dingbat board

I want to make sure I am setting this up correctly

Here is the signal path

Guitar to pedals( always in use pedals)

Out of the last pedal into the input on the px-8

I have 5 pedals in the loop right now so loops 1 through 5 are in use

To each of these loops I am using the send to one pedal and output of the same pedal back into that specific loop

Then I am using the main output back to the amplifier

Am I doing something wrong I am not having success at this point...

Cheers and thank you for any thoughts or recommendations!

Boneguitar

Author:  JohnClark [ Wed Jan 03, 2018 11:04 am ]
Post subject:  Re: Px plus general set up before programming

Your description of the setup seems fine. What problem are you having? No signal at all? Dry signal but no effects?

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/