Voodoo Lab
http://www.voodoolab.com/forum/

Hex switcher question
http://www.voodoolab.com/forum/viewtopic.php?f=9&t=8447
Page 1 of 1

Author:  claxor [ Wed Sep 27, 2017 9:10 pm ]
Post subject:  Hex switcher question

I just bought a rack shelf made for the Hex switcher, and it didn't come with screws to attach the Hex switcher to the VL shelf made for it.

Where are the screws, or how do I attach the Hex to this rack shelf?

Author:  JohnClark [ Thu Sep 28, 2017 9:48 am ]
Post subject:  Re: Hex switcher question

You could say that the screws came with the HEX ;)

The HEX mounts to the HEX Rackmount Bracket using the two #2 Phillips Head screws along the front edge of the bottom of the HEX chassis. Pull them out of the HEX, then set set the HEX on the bracket aligned over the holes in the bracket, then put the screws thru the bracket and into the HEX.

Let us know if you run into any troubles!

Author:  claxor [ Thu Sep 28, 2017 10:07 am ]
Post subject:  Re: Hex switcher question

Ok, I assumed so. Thanks

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/