It is currently Tue Nov 21, 2017 5:24 am

All times are UTC - 8 hours [ DST ]





Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Feed Thru on DMC GCX
PostPosted: Thu Aug 24, 2017 2:52 am 
Offline

Joined: Thu Aug 24, 2017 2:33 am
Posts: 2
Hi,
the old DMC version of the GCX has two "Feed Thru In's" in the front and
two "Feed Thru Out's" in the rear. While the new Voodoo Lab GCX has a "Guitar In"
and a single "Feed Thru" in the front and a corresponding "Feed Through" in the rear.

The feed thru for the Voodoo Lab version works in both directions. Is this also the case
with the DMC version? I'm unsure as they are specifically labeled In and Out, but the
not on the Voodoo Labs version.

If it only works front to back on the DMC version, can it be modified to work in both directions?

Thanks!


Top
 Profile  
 
 Post subject: Re: Feed Thru on DMC GCX
PostPosted: Thu Aug 24, 2017 11:31 am 
Offline

Joined: Tue May 05, 2009 2:33 pm
Posts: 6756
Location: The Lab
The older "Feedthrus 1 & 2" GCX has independent buffer on each feedthru. So yes, it will only pass signal from the front to the rear.

If you needed a non buffered passthru then I suppose you could simply de-solder the existing jacks from the circuit board and run a shielded cable between them.

I hope that helps!


Top
 Profile  
 
 Post subject: Re: Feed Thru on DMC GCX
PostPosted: Fri Aug 25, 2017 1:52 pm 
Offline

Joined: Thu Aug 24, 2017 2:33 am
Posts: 2
Thanks! That helps a lot :-) I think I'll try your suggestion.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: