Amp Selector question

Q & A for building and interfacing your rack gear with Ground Control Pro and GCX-based systems.
Post Reply
Gdawg007
Posts: 2
Joined: Mon Jul 25, 2016 11:01 am

Amp Selector question

Post by Gdawg007 » Mon Jul 25, 2016 11:08 am

I searched the forum before posting but didn't see my questions so hopefully I'm not repeating something. If so, I'm sorry.

I have 3 amps I'm looking to run either one at a time or perhaps a couple at the same time. One of them is a deluxe reverb that has two inputs for two different channels. In front of that amp, I want to run a couple pedals. I do not want to run those pedals in front of the other two amps. So if I use the Amp Selector, can I take the output and/or outputs for the deluxe reverb into pedals? Or does the amp selector need to be the last thing right before the amp?

JohnClark
Posts: 7079
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: Amp Selector question

Post by JohnClark » Mon Jul 25, 2016 12:07 pm

You can run pedals after the outputs of the Amp Selector.

On your Fender amp, I am unsure if you will be able to use both inputs. These amps usually have the two sections out of phase with eachother.

I hope that helps!

Post Reply