It is currently Mon Nov 20, 2017 12:08 pm

All times are UTC - 8 hours [ DST ]





Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: How to use Boss LS -2 with GCX / GCP
PostPosted: Tue Jan 26, 2016 11:50 am 
Offline

Joined: Tue Jan 26, 2016 11:46 am
Posts: 3
Hi, I have a bass pedalboard which utilizes a boss Ls 2 to split it into two chains, allowing me to have effects with a clean blend. How would I wire this with GCX and GDP?


Top
 Profile  
 
 Post subject: Re: How to use Boss LS -2 with GCX / GCP
PostPosted: Wed Jan 27, 2016 7:27 am 
Offline

Joined: Mon Jan 25, 2010 8:53 am
Posts: 1313
Welcome to the board!!

How are you using the LS-2 now? If you could give us an idea as to what your current signal chain looks like, it would be easier to offer suggestions on incorporating it into a GCPro/GCX rig.

_________________
I am not affiliated with Voodoo Lab in any way, just sharing what little MIDI and signal routing knowledge I have. If you found my assistance helpful, please pay it forward.


Top
 Profile  
 
 Post subject: Re: How to use Boss LS -2 with GCX / GCP
PostPosted: Wed Jan 27, 2016 2:22 pm 
Offline

Joined: Tue Jan 26, 2016 11:46 am
Posts: 3
Bass signal into L's 2 which then has the output into the amp.
Loop A: boss tu3, ehx octave multiplexer, boss ds 1, boss ce3
Loop B: boss tu3, DigiTech bass syntu wah, ehx big muff

The wet output on the octave multiplexer goes to a guitar amp

I use the ls2 in 2 ways, to run both loops at once with different pedals on each, and to run one loop with the other as a clean blend. The tu3 in each acts as a killswitch for each loop.


Top
 Profile  
 
 Post subject: Re: How to use Boss LS -2 with GCX / GCP
PostPosted: Thu Jan 28, 2016 5:18 am 
Offline

Joined: Mon Jan 25, 2010 8:53 am
Posts: 1313
It would be simpler to replicate exactly what you're doing now with two GCX loops and eliminate the LS-2 entirely, along with one of the TU3s.

_________________
I am not affiliated with Voodoo Lab in any way, just sharing what little MIDI and signal routing knowledge I have. If you found my assistance helpful, please pay it forward.


Top
 Profile  
 
 Post subject: Re: How to use Boss LS -2 with GCX / GCP
PostPosted: Thu Jan 28, 2016 9:43 am 
Offline

Joined: Tue Jan 26, 2016 11:46 am
Posts: 3
But how would I then get the clean blend with it?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: