I just got my Axe FX II and am setting it up with my Voodoo Labs Ground Control Pro. I have enabled the 4 preset mode which allows the other 8 buttons for instant access...toggling on/off fx.

It all works well except that I am finding if I have IA button 1 setup for Drive 1 Bypass (in the I/O-->CTRL) it does toggle the drive on and off but it depends on the initial state of the effect. For example, I have a preset with the drive "on" and when I switch to that patch the drive is on but the light on the GCP button 1 is off. I click it once and it (the light) comes one....drive still active...click it again and the drive goes off and the light goes off. Is there anyway to have the GCP accurately represent the state of the drive when coming to the preset?

Hope this all makes sense

Thanks,
d.

You simply program the state the Instant Access LED should be into each Ground Control Pro preset. To make the Instant Access button LED status match the effects that are active for any Ground Control Pro preset:

1. Call up the Ground Control Pro preset that you want to edit.
2. Press any of the Instant Access buttons that should be "on" for this preset.
3. Press and hold the EDIT button.
4. Once the Ground Control Pro screen changes, press the EDIT button again.
5. Press the YES button to save the changes.
6. Repeat steps 1-5 for each Ground Control Pro preset that has active effects.

I hope that helps!

awesome.......thanks!