Pedal Switcher: Changing TRS Insert Point

Q & A for building and interfacing your rack gear with Ground Control Pro and GCX-based systems.
Post Reply
JAMc
Posts: 11
Joined: Tue Aug 10, 2010 2:25 pm
Location: Ben Lomond, CA

Pedal Switcher: Changing TRS Insert Point

Post by JAMc » Mon Apr 02, 2012 8:31 pm

In a Pedal Switcher, is there a way to move the TRS insert point from Ch3-TRS-Ch4 to Ch2-TRS-Ch3?

I would like to have my Eventide PitchFactor & Modfactor before a volume pedal in the TRS, followed by a Strymon TimeLine & Space. I control the the PS and the pedals with a GCP.

Many Thanks!
It's all about tone!

nyteowl
Posts: 1325
Joined: Mon Jan 25, 2010 8:53 am

Re: Pedal Switcher: Changing TRS Insert Point

Post by nyteowl » Wed Apr 04, 2012 6:18 am

JAMc wrote:In a Pedal Switcher, is there a way to move the TRS insert point from Ch3-TRS-Ch4 to Ch2-TRS-Ch3?

I would like to have my Eventide PitchFactor & Modfactor before a volume pedal in the TRS, followed by a Strymon TimeLine & Space. I control the the PS and the pedals with a GCP.

Many Thanks!
I don't think this is possible. Per Page 6 of the Pedal Switcher manual:

"Pedal Switcher audio loops are all hard-wired together in series."

I suspect the only way to accomplish what you want would be by opening the unit up and modding the circuit board.
I am not affiliated with Voodoo Lab in any way, but enjoy sharing what little MIDI and signal routing knowledge I have. If you find my assistance helpful, please pay it forward.

Post Reply