hiya, i really need some help please!

I have a diezel vh4 amp, a line 6 m9 in the fx loop and a ground control pro.

i am trying to figure out if the below configuation is possible -

i have a midi cable running from the GCP (midi out) to the VH4 (midi in) and then a second midi cable running from the VH4 (midi thru) to the M9 (midi in)

i would like to be able to have buttons 1 - 4 on the GCP to switch ONLY the amp channels, 1,2,3,4.

i would then like to have buttons 5 - 12 to act as a "virtual" pedal board switching ONLY the presets on the M9. in other words i would like to "split" the buttons on the GCP so that the first row (1-4) ONLY controls the amp switching and then the second and third rows (5-12) control ONLY the m9 preset switching.

i hope that makes sense! is this possible? thanks!!

please guys, can anyone help me?!

If you set the Ground Control Pro up in 10 presets per bank, you should be able to set the presets to control only one device at a time. This will require that you recall scenes from the M9 rather than individual effects.

I hope that helps!