Finally i have all the pieces together.But i would like to have a little help from you guys.
This is my equipment.

Amp: Diezel VH4
Effects: MXR Black Label Chorus
MXR EVH Phase 90
MXR EVH Flanger
MXR Phase 100
TC Electronic Flashback
Dunlop Wah and a Tuner

Now this is what i would like to do.


The Wah and the Tuner is in front of the amp.
The Flashback is in the parallel Loop and the other Effects are in the serial Loop of the Amp.

How should i wire everything that it works?

Happy new year!!!

Can you help me out John?

Here are some examples that should help to get you started.

http://www.voodoolab.com/gcxdiagrams/05 ... tching.pdf

In this diagram GCX Loops 1-3 are controlling pedals that are routed to the front end of the amp. I assume that you will keep the wah out on the floor so I am unsure if this part is of much concern to you.
GCX Loop 4 is being used to switch a device that is routed to a parallel effect loop. You would connect the Flashback the same way using any unused GCX Loop routed to the parallel effects loop on your amp.


http://www.voodoolab.com/gcxdiagrams/01 ... _AmpSw.pdf

In this diagram GCX Loops 5 and 6 are controlling two devices that are routed through a series effects loop. You would simply use four unused GCX Loops to connect your four pedals and route them through the series effects loop on your amp.

I hope this helps!