How to use Ground Control Pro with three HEX.

Q & A for building and interfacing your rack gear with Ground Control Pro and GCX-based systems.
Post Reply
seguroloureiro
Posts: 1
Joined: Tue Apr 23, 2019 12:18 am

How to use Ground Control Pro with three HEX.

Post by seguroloureiro » Tue Apr 23, 2019 12:29 am

Good morning, I would like, if possible, ir someone code tale me a question about the use of my ground control pro and three hex simultaneously. What happens is that I would like to have access to each one of the loops ou me hex , I can connect the loops of my first hex through gcp, but the following ones, even after they are activated, can only be accessed when I am programming the hex. pressets. Thank you
Ricardo Loureiro

JohnClark
Posts: 7238
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: How to use Ground Control Pro with three HEX.

Post by JohnClark » Tue Apr 23, 2019 10:35 am

The Ground Control Pro has Eight Instant access buttons. These can be programmed to control any loop in your system, but you are limited to a total of Eight Instant Access switches.

Ground Control Pro Presets will set all all the loops at once for repeatable loop combinations without having to step on a bunch of buttons.

I hope that helps!

Post Reply