Voodoo Lab
http://www.voodoolab.com/forum/

handles for the board
http://www.voodoolab.com/forum/viewtopic.php?f=8&t=8801
Page 1 of 1

Author:  larryguitar19 [ Wed Jan 31, 2018 10:24 pm ]
Post subject:  handles for the board

Hello all. I'm new to the board. I just bought the Dingbat Medium with the Mondo and PX8.

Most of the boutique boards have some sort of handle.

I would like to attach some handles on the sides of the Dingbat. The predrilled holes on the sides are about 2 7/8' apart or something but in any event don't accommodate any cabinet pulls that I've found. I have thought about getting a knob with a bar shape.

I don't know if that will be sturdy enough with only one screw attachment. I think after a couple uses it will wear or fatigue.

But I wonder if anybody has some ideas.

Author:  JohnClark [ Thu Feb 01, 2018 11:36 am ]
Post subject:  Re: handles for the board

A knob or two would probably be fine... will you be mounting it on top or out the bottom?

Alternatively, it isn't too difficult to drill holes in aluminum ;) (Masking tape over the area where you intend to drill can help keep the edges of the powdercoat from chipping)

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/