handles for the board

Exchange tips and tricks to help you design the ultimate pedalboard.
Post Reply
larryguitar19
Posts: 4
Joined: Wed Jan 31, 2018 10:17 pm

handles for the board

Post by larryguitar19 » Wed Jan 31, 2018 10:24 pm

Hello all. I'm new to the board. I just bought the Dingbat Medium with the Mondo and PX8.

Most of the boutique boards have some sort of handle.

I would like to attach some handles on the sides of the Dingbat. The predrilled holes on the sides are about 2 7/8' apart or something but in any event don't accommodate any cabinet pulls that I've found. I have thought about getting a knob with a bar shape.

I don't know if that will be sturdy enough with only one screw attachment. I think after a couple uses it will wear or fatigue.

But I wonder if anybody has some ideas.

JohnClark
Posts: 7086
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: handles for the board

Post by JohnClark » Thu Feb 01, 2018 11:36 am

A knob or two would probably be fine... will you be mounting it on top or out the bottom?

Alternatively, it isn't too difficult to drill holes in aluminum ;) (Masking tape over the area where you intend to drill can help keep the edges of the powdercoat from chipping)

Post Reply