Voodoo Lab
http://www.voodoolab.com/forum/

Pedal Power ISO-5 and MXR M300 reverb pedal issues
http://www.voodoolab.com/forum/viewtopic.php?f=8&t=7655
Page 1 of 1

Author:  Smeafer [ Sat Jun 03, 2017 10:19 am ]
Post subject:  Pedal Power ISO-5 and MXR M300 reverb pedal issues

Hi folks,

I purchase the Pedal Power ISO-5 and MXR M300 reverb pedal. Upon setup it worked great. I recently got a new pedal board and set it up again. My reverb pedal would not power up. I switched the inputs from another pedal and the MXR worked for a moment and started to bling red and blue. I've sent a email to Dunlop asking what that is. I then connected it to a 12v input and it worked. Im worried that since this is a 9v it will ruin my pedal. Should I try and use the first 9v input on the chain or are there any suggestions? Thanks!

Author:  JohnClark [ Tue Jun 13, 2017 12:47 pm ]
Post subject:  Re: Pedal Power ISO-5 and MXR M300 reverb pedal issues

Sorry for the late reply here!

The M300 should be powered from the High Current 9V Output on the ISO-5. I would not use the 12V Output for this.

Let us know how it goes!

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/