Pedal Power ISO-5 and MXR M300 reverb pedal issues

Exchange tips and tricks to help you design the ultimate pedalboard.
Post Reply
Smeafer
Posts: 1
Joined: Sat Jun 03, 2017 10:11 am

Pedal Power ISO-5 and MXR M300 reverb pedal issues

Post by Smeafer » Sat Jun 03, 2017 10:19 am

Hi folks,

I purchase the Pedal Power ISO-5 and MXR M300 reverb pedal. Upon setup it worked great. I recently got a new pedal board and set it up again. My reverb pedal would not power up. I switched the inputs from another pedal and the MXR worked for a moment and started to bling red and blue. I've sent a email to Dunlop asking what that is. I then connected it to a 12v input and it worked. Im worried that since this is a 9v it will ruin my pedal. Should I try and use the first 9v input on the chain or are there any suggestions? Thanks!

JohnClark
Posts: 7129
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: Pedal Power ISO-5 and MXR M300 reverb pedal issues

Post by JohnClark » Tue Jun 13, 2017 12:47 pm

Sorry for the late reply here!

The M300 should be powered from the High Current 9V Output on the ISO-5. I would not use the 12V Output for this.

Let us know how it goes!

Post Reply