VL Amp Selector trouble

jfplumb@mac.com · **Posted:** Sat Jan 14, 2012 9:18 am

I just picked one up yesterday. Spent about an hour last night trying to get it to work properly.
The buttons dont seem to do anything. Only the volume knobs turn the signal from off to on (and sad tone too)
Is there a reset or is this thing in need of service?

All ground toggles are in the up position.
I am using the VL ISO-5 power supply.

Help please.
Thanks,
J

thepowerdave · **Joined:** Thu Feb 02, 2012 3:43 pm **Posts:** 2

I have the same trouble :evil:

Do you find the solution???

jfplumb@mac.com wrote:

I just picked one up yesterday. Spent about an hour last night trying to get it to work properly.
The buttons dont seem to do anything. Only the volume knobs turn the signal from off to on (and sad tone too)
Is there a reset or is this thing in need of service?

All ground toggles are in the up position.
I am using the VL ISO-5 power supply.

Help please.
Thanks,
J

jfplumb@mac.com · **Posted:** Thu Feb 02, 2012 4:20 pm

Return for repairs...been a while getting back too. Boooooo. I want it to work so badly. Good luck.

thepowerdave · **Joined:** Thu Feb 02, 2012 3:43 pm **Posts:** 2

So, I have to go to proshop too!!! Does your pedal is now on repair???

JohnClark · **Posted:** Tue Feb 07, 2012 12:29 pm

Is it possible that these were just in Program Mode? In order to be in Play Mode, make sure to power up the Amp Selector without holding down any of the buttons.

@jbplumb, did you send your Amp Selector to us?

VL Amp Selector trouble

Who is online