Page 1 of 1

PX-8 Plus: FX Loop Problems

Posted: Sun Oct 27, 2019 5:56 pm
by StringSinger
Hi,

I have a Dingbat with integrated PX-8 Plus powered by a Pedal Power Plus 2. I really want to use the second channel of my Mesa Filmore on the high setting for some parts and have some delay as well. So I want to do a four cable method with the PX-8+ using the insert loop between loops 6 & 7. However, I've gotten the following results trying it 2 different ways:

Scenario 1: Standard PX-8+ Setup
Loss of low-end frequencies and other tone changes when the FX Loop is used.

Scenario 2: PX-8+ with the internal jumper set to Bypass(vs. Quiet Switching)
Tone is fine but a very loud hum is present when the FX loop cables are plugged in.

Any ideas, input etc. on how to make this work would be great because everything would be great if I could make this work without it having an effect on the tone.

Re: PX-8 Plus: FX Loop Problems

Posted: Mon Oct 28, 2019 6:31 pm
by StringSinger
Forgot to mention. There is no hum when I just hook my DD-500(bypassing the PX-8+) into the FX Loop.

Re: PX-8 Plus: FX Loop Problems

Posted: Thu Oct 31, 2019 12:41 pm
by JohnClark
So there was no hum when you had the jumpers set to Quiet Switching, just the tonal change? did the hum happen even with all loops bypassed?

Just to be sure we have things connected properly, here is a quick rundown of the necessary connections. All connections should be made directly with a single cable, bypassing any interface boxes or patch-bays for the purposes of testing.

1. Guitar to PX-8+ Input.
2. PX-8+ Insert Send to the Instrument Input on your amp.
3. Amp FX Send to PX-8+ Insert Return.
4. PX-8+ Output to your amp's FX Return.

With all loops bypassed, or even without any pedals connected would be the first test to try to narrow down the source of the hum.

Let us know how it goes!