Pedal Power 2 Plus for Elektron Analog Drive

General discussion and tech talk about the industry standard Pedal Power line of power supplies.
Post Reply
Billyk
Posts: 1
Joined: Wed Mar 14, 2018 1:32 pm

Pedal Power 2 Plus for Elektron Analog Drive

Post by Billyk » Wed Mar 14, 2018 1:36 pm

Requesting to see if my Elektron pedal, "Analog Drive" can utilize power from my “Voodoo Labs Pedal Power 2 Plus”?

The Analog Drive Pedal Unit power consumption: 5 W, 400 mA typical.

The power supply used for the Analog Drive is Elektron PSU-3b.
Input Voltage Range: 100-240V AC/50-60Hz,
Output Amps: 2.5A,
Output Voltage: 12V DC
Sleeve/Tip Configuration: Sleeve: Negative, Tip/Center: Positive.

I hope this is enough info to help. Also if I can use it, which output on the Power 2 Plus I can use and which position do I put the DIP switch in.

Thanks everyone so much for your time,

JohnClark
Posts: 7040
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: Pedal Power 2 Plus for Elektron Analog Drive

Post by JohnClark » Thu Mar 15, 2018 12:33 pm

The Analog Drive can be powered using one of the included cables with the Red end together with our optional Current Doubler Adapter (the one with the Green end) connected to both outputs 5 and 6 with the corresponding DIP switches set away from Normal.

I hope that helps!

Post Reply