Voodoo Lab
http://www.voodoolab.com/forum/

Powering Boss MS3
http://www.voodoolab.com/forum/viewtopic.php?f=7&t=8762
Page 1 of 1

Author:  mbman [ Thu Jan 18, 2018 10:21 am ]
Post subject:  Powering Boss MS3

Can I use my PP2+ to power a Boss MS3 and a Shure GLXD receiver?

TIA

Author:  JohnClark [ Thu Jan 18, 2018 5:37 pm ]
Post subject:  Re: Powering Boss MS3

The MS-3 draws close to 300mA so it will need a Current Doubler Adapter (the one with the Green end) connected to Output 5 or 6 and any other output with both corresponding DIP Switches set to Normal.

The GLXD can be powered from output 5 or 6 and the corresponding DIP switch can actually be set either direction.

I hope that helps!

Author:  swylbilly [ Fri Feb 16, 2018 4:42 pm ]
Post subject:  Re: Powering Boss MS3

JohnClark wrote:
The MS-3 draws close to 300mA so it will need a Current Doubler Adapter (the one with the Green end) connected to Output 5 or 6 and any other output with both corresponding DIP Switches set to Normal.


Hi John, I also have an MS-3, I'm using a pedal power Mondo. Would I be able to power the MS-3 with one of the 9V 400Ma outs? Thanks

Author:  JohnClark [ Tue Feb 20, 2018 10:43 am ]
Post subject:  Re: Powering Boss MS3

swylbilly wrote:
Hi John, I also have an MS-3, I'm using a pedal power Mondo. Would I be able to power the MS-3 with one of the 9V 400Ma outs? Thanks


No problem to use a single 9V/400mA Output for powering the MS-3.

Good Luck!

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/