Page 1 of 1

PP2Plus Question

Posted: Sat Dec 23, 2017 5:29 am
by sabbathisgod

I bought a PP2 Plus brand new a year ago, and haven't had any issues until recently when I purchased a TC Electronic Tailspin Vibrato. At first I couldn't get the pedal to play and thought it was broken, until I unplugged it from Output 1 to 2 on the PP2 Plus and it worked fine. I checked the remaining outputs and they all worked except number 1.

Tonight I noticed my reverb pedal, which is last on the chain before the amplifier, and plugged into Output 1 was emitting a loud hum. I switched it over to 2 and on the PP2 and the humming stopped. Thoughts about this? Thanks for reading!

Re: PP2Plus Question

Posted: Tue Jan 02, 2018 12:47 pm
by JohnClark
That is a strange issue!

Make sure the DIP switch for Output 1 is set to the Normal position for 9V operation.

If still giving you trouble, feel free to give us a call or write to so we can arrange for an inspection. Be sure to mention this post so you don't have to explain everything all over again ;)

I hope that helps!