It is currently Mon Nov 20, 2017 5:14 am

All times are UTC - 8 hours [ DST ]





Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: TC electriconics X4 Looper issue
PostPosted: Wed Nov 15, 2017 8:58 pm 
Offline

Joined: Wed Nov 15, 2017 8:53 pm
Posts: 1
Hello,
I have a problem I can't figure out.
I purchased the "pedal power Mondo" today. I plugged my "TC electriconics X4 Looper" into one of the 9V (or 12V) jacks. What happened was that all of the lights on the pedal and wouldn't turn off and the pedal wouldn't work. I then plugged it into one of the 9V high-current outputs jacks and that solved the issue.
My question is why that happened. Did I do something wrong or potentially dangerous for my pedal?

Thanks,
George.


Top
 Profile  
 
 Post subject: Re: TC electriconics X4 Looper issue
PostPosted: Thu Nov 16, 2017 12:33 pm 
Offline

Joined: Tue May 05, 2009 2:33 pm
Posts: 6751
Location: The Lab
If this is the Ditto X4, then it should be able to be powered from any one of the four 9V 400mA outputs using one of the included all black standard barrel cables.
It should not be connected to either of the 12V outputs.
If you do use it from one of the 9V/12V sections, definately use the 9V jack but maybe be sure to not use the adjacent 12V jack for anything else in case the common ground between these two jacks was the problem.

I hope that helps!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: Bing [Bot] and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: