Page 1 of 1

tc vintage delay with pp2+

Posted: Sun Aug 27, 2017 8:35 am
by latria84
hello everybody,

does this delay pedal works with the pp2+???

specs 12V AC min 300mA
http://www.tcelectronic.com/vintage-delay/tech-specs/


thank you very much,

Re: tc vintage delay with pp2+

Posted: Mon Aug 28, 2017 12:02 pm
by JohnClark
The link you provide says 12VDC...

That said, I believe the Vintage Delay draws much less than the stated 300mA and can actually be powered from a Pedal Power 2+ directly from output 5 or 6 with the corresponding DIP switch set away from Normal.

I hope that helps!

Re: tc vintage delay with pp2+

Posted: Mon Aug 28, 2017 9:24 pm
by latria84
ok thanks,

doe this cable works correctly with ?

https://www.thomann.de/fr/voodoo_lab_cu ... dapter.htm

Re: tc vintage delay with pp2+

Posted: Tue Aug 29, 2017 9:45 am
by JohnClark
The Current Doubler would be unnecessary. You can use one of the standard all black barrel cables included with your Pedal Power 2+ to power this pedal from a single output if you use output 5 or 6 with the corresponding DIP switch set away from Normal.

However, if you were already using these outputs you could actually use the Current Doubler on any two of outputs 1-4 with the corresponding DIP switches set away from Normal.

Are you already using outputs 5 and 6 for something else?

Re: tc vintage delay with pp2+

Posted: Tue Aug 29, 2017 10:45 am
by latria84
thanks so much

no not yet.

I try tonight