tc vintage delay with pp2+

General discussion and tech talk about the industry standard Pedal Power line of power supplies.
Post Reply
latria84
Posts: 3
Joined: Sun Aug 27, 2017 8:32 am

tc vintage delay with pp2+

Post by latria84 » Sun Aug 27, 2017 8:35 am

hello everybody,

does this delay pedal works with the pp2+???

specs 12V AC min 300mA
http://www.tcelectronic.com/vintage-delay/tech-specs/


thank you very much,

JohnClark
Posts: 7131
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: tc vintage delay with pp2+

Post by JohnClark » Mon Aug 28, 2017 12:02 pm

The link you provide says 12VDC...

That said, I believe the Vintage Delay draws much less than the stated 300mA and can actually be powered from a Pedal Power 2+ directly from output 5 or 6 with the corresponding DIP switch set away from Normal.

I hope that helps!

latria84
Posts: 3
Joined: Sun Aug 27, 2017 8:32 am

Re: tc vintage delay with pp2+

Post by latria84 » Mon Aug 28, 2017 9:24 pm

ok thanks,

doe this cable works correctly with ?

https://www.thomann.de/fr/voodoo_lab_cu ... dapter.htm

JohnClark
Posts: 7131
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: tc vintage delay with pp2+

Post by JohnClark » Tue Aug 29, 2017 9:45 am

The Current Doubler would be unnecessary. You can use one of the standard all black barrel cables included with your Pedal Power 2+ to power this pedal from a single output if you use output 5 or 6 with the corresponding DIP switch set away from Normal.

However, if you were already using these outputs you could actually use the Current Doubler on any two of outputs 1-4 with the corresponding DIP switches set away from Normal.

Are you already using outputs 5 and 6 for something else?

latria84
Posts: 3
Joined: Sun Aug 27, 2017 8:32 am

Re: tc vintage delay with pp2+

Post by latria84 » Tue Aug 29, 2017 10:45 am

thanks so much

no not yet.

I try tonight

Post Reply