It is currently Tue May 22, 2018 4:07 pm

All times are UTC - 8 hours [ DST ]





Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Power supply for Atomic ampli-firebox and power amp
PostPosted: Sat Apr 14, 2018 9:20 am 
Offline

Joined: Thu Jun 09, 2016 4:06 pm
Posts: 3
I'm looking to build a little compact practice rig based around the atomic Ampli-firebox, and a pedal sized power amp. I was debating between the Seymour duncan powersatge 170, the quilter micro block 45, and the mooer baby boomer. I'm pretty gear savy, but I'm not very well versed when it comes to powering different types of pedals with different voltages. Would a pedal power 2 plus be able to power the maple-firebox and one of those power amps, or would I need something different?


Top
 Profile  
 
 Post subject: Re: Power supply for Atomic ampli-firebox and power amp
PostPosted: Wed Apr 18, 2018 3:54 pm 
Offline

Joined: Tue May 05, 2009 2:33 pm
Posts: 6986
Location: The Lab
The Pedal Power 2+ can power the Ampli-FireBox from output 5 or 6 with the corresponding DIP Switch set to Normal.

Any Power Amp pedal will likely have vary large current demands and/or higher voltage requirements. These should be powered from the supplied adapter using the Courtesy Outlet on the back of the Pedal Power 2+.

I hope that helps!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: