Wireless recievers?

General discussion and tech talk about the industry standard Pedal Power line of power supplies.
Post Reply
skibob
Posts: 4
Joined: Tue May 12, 2009 2:25 pm

Wireless recievers?

Post by skibob » Tue May 12, 2009 2:28 pm

Just wondering... Can the Pedal Power 2 Plus safely power a Shure PGX4 wireless receiver?

The power reqs for the PGX says 12-18Vdc at 150 mA. The PP2P would also be running a couple of distortion pedals, like a TS9 and an OCD.

Thanks...

Josh Fiden
Site Admin
Posts: 177
Joined: Tue Mar 10, 2009 11:36 pm

Re: Wireless recievers?

Post by Josh Fiden » Tue May 12, 2009 10:29 pm

This should be okay from outputs 5 or 6 with the DIP switch set away from normal.

**NOTE: Check the polarity on the power supply, this may be center positive! You need to verify this and then use a reverse polarity cable.

Because all Pedal Power 2+ outputs are isolated, you can power devices that require either polarity by using the correct cable.

Please post your results, thanks!

Regards,
Josh Fiden
Founder / CEO

Post Reply