PP2 Plus with vintage pedals and Octavio

General discussion and tech talk about the industry standard Pedal Power line of power supplies.
Post Reply
earSmoke
Posts: 2
Joined: Thu Aug 27, 2009 11:33 am

PP2 Plus with vintage pedals and Octavio

Post by earSmoke » Thu Aug 27, 2009 11:52 am

I'm ready to pull the trigger on the PP2 but have a couple of questions first before making the investment. I have the following:

Dunlop Octavio (new reissue)
Boss CS-1 Compressor Sustainer
Dunlop Crybaby GCB-95 Wah
EH Big Muff Pi (modded)
Morley Black Gold Basic Volume pedal
Boss CE-1 Chorus Ensemble
Ibanez AD-80 Analog Delay (18V)

The CE-1 is AC so no worries there.

I'm curious which pedal will go into which plug, specifically the Octavio. Would the Octavo go to one of the 'sag' plugs? I've read where fuzzes, etc. like the varying voltage but not sure about the Octavio. I know the CS-1 uses ACA so that's ok with the PP2, I think.

Any problem powering the AD-80 with the 18V? Guess I'll need to order a special plug for that one.

Any other suggestions or comments?


thanks,

Trueman
Posts: 117
Joined: Fri May 15, 2009 3:08 am
Location: New Zealand!
Contact:

Re: PP2 Plus with vintage pedals and Octavio

Post by Trueman » Fri Aug 28, 2009 1:37 pm

I can't see any obvious problems there. You will need the PPY cable for 18V, can be ordered direct from Voodoo Labs or from any dealers. Regarding the SAG, some say they prefer fuzz pedals at 4.5 V, some prefer at full 9V, my advice just try it for yourself!
Connoisseur of good tone.

http://www.john-trueman.com : Guitarist from Down Under
http://www.guitarpedals.co.nz

earSmoke
Posts: 2
Joined: Thu Aug 27, 2009 11:33 am

Re: PP2 Plus with vintage pedals and Octavio

Post by earSmoke » Mon Aug 31, 2009 5:38 am

Thanks!

Post Reply