Page 1 of 1

Output Splitter Cable Problem

Posted: Mon Jan 28, 2013 6:54 pm
by theryanpaul
I own a PP2+ and need to power 10 pedals.

So I bought 2 cable splitters from you guys and only 1 side of each cable works. The pedals I am trying to use with them are

zvex Box of Rock
T1M Buffer

Loopmaster Looper
Boss DS1 with JHS synth Mod

I am using output 7 and 8

I am rebuilding my pedalboard right now and need to get it done asap.

Any help?

I can give you the run down of every pedal I am powering if that would help

thanks!
Ryan

Re: Output Splitter Cable Problem

Posted: Wed Jan 30, 2013 9:37 pm
by Josh Fiden
theryanpaul wrote:I own a PP2+ and need to power 10 pedals.

So I bought 2 cable splitters from you guys and only 1 side of each cable works. The pedals I am trying to use with them are

zvex Box of Rock
T1M Buffer

Loopmaster Looper
Boss DS1 with JHS synth Mod
The Loopmaster only uses power to operate LEDs, so there is no connection to audio ground. It won't work with a splitter cable. I haven't tried the T1M, but suspect a similar problem. You need to pick different pedals to combine with the splitter.

Regards,

Josh Fiden
Founder/MFCEO

http://www.facebook.com/scarygoodtone