Output Splitter Cable Problem

General discussion and tech talk about the industry standard Pedal Power line of power supplies.
Post Reply
theryanpaul
Posts: 1
Joined: Mon Jan 28, 2013 6:46 pm

Output Splitter Cable Problem

Post by theryanpaul » Mon Jan 28, 2013 6:54 pm

I own a PP2+ and need to power 10 pedals.

So I bought 2 cable splitters from you guys and only 1 side of each cable works. The pedals I am trying to use with them are

zvex Box of Rock
T1M Buffer

Loopmaster Looper
Boss DS1 with JHS synth Mod

I am using output 7 and 8

I am rebuilding my pedalboard right now and need to get it done asap.

Any help?

I can give you the run down of every pedal I am powering if that would help

thanks!
Ryan

Josh Fiden
Site Admin
Posts: 177
Joined: Tue Mar 10, 2009 11:36 pm

Re: Output Splitter Cable Problem

Post by Josh Fiden » Wed Jan 30, 2013 9:37 pm

theryanpaul wrote:I own a PP2+ and need to power 10 pedals.

So I bought 2 cable splitters from you guys and only 1 side of each cable works. The pedals I am trying to use with them are

zvex Box of Rock
T1M Buffer

Loopmaster Looper
Boss DS1 with JHS synth Mod
The Loopmaster only uses power to operate LEDs, so there is no connection to audio ground. It won't work with a splitter cable. I haven't tried the T1M, but suspect a similar problem. You need to pick different pedals to combine with the splitter.

Regards,

Josh Fiden
Founder/MFCEO

http://www.facebook.com/scarygoodtone

Post Reply