Earthquaker Devices Disaster Transport + PP2

General discussion and tech talk about the industry standard Pedal Power line of power supplies.
Post Reply
artmx47
Posts: 1
Joined: Fri Feb 03, 2012 1:31 pm

Earthquaker Devices Disaster Transport + PP2

Post by artmx47 » Fri Feb 03, 2012 1:40 pm

I have been using for a while a PP2 and today I received the Earthquaker Devices Disaster Transport delay pedal. The power requirement of this pedal is 9v with a negative center. The matter is that I already used the 1-5 outputs. Is it fine to use the #7 or #8 outputs to power this pedal? It's a digital delay and I don't intend to use the SAG properties. Thanks in advance.

JohnClark
Posts: 7088
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: Earthquaker Devices Disaster Transport + PP2

Post by JohnClark » Tue Feb 07, 2012 1:04 pm

I don't see a current rating for this pedal, but you can certainly try it in any output with the corresponding DIP switch set to Normal. If it draws more than 100mA then you will have to power it from either output 5 or 6 with the DIP switch set to Normal.

I hope that helps!

Post Reply