Hello,

I recently purchased at PP2+ and am now incorporating it into my pedal board. The only pedal I have some concern for is the Guyatone VT-X Vintage Tremolo. It requires 12VDC and 160mA. Should I use slots 5 or 6, and flip the DIP switches away from NORMAL to get the right power/voltage to this pedal?

Thanks

So I hooked it up to port 6, flipped the dip switch on and connected it with a center-negative barrel connector and it didn't sound right. It was emitted a loud whoosing/tremolo sound even when no notes were being played.

I flipped the DIP switch to normal and the it worked? seems strange since it is working on only 9V now, when it claims to need 12?

any thoughts?