Voodoo Lab

That’s it, spot on

No, the relays can’t handle that current.

Hi there, I’d see if you can find the closest distributor or seller and see if they can get it repaired for you. There was a recall or something with certain boards that had problems with the switches, you could get onto Voodoo and see if it is one of the ones that had the switches changed or buy a ...

Hi there, Since you have it apart, have you used a multimeter to see if the switches actually switch? I know you can get these switches from electronic distributors, so if you are good with a soldering Iron you can do it yourself or get someone to do it. If you are in the US, email or Call Voodoo an...

Hi there, if you have a stereo setup, you will have 2 paths. So you have 2 amps etc. If you Yamaha Stomp is your stereo split, it is first in line. So, all mono effects go before this, like you distortion, boost etc. then after this it becomes L & R. So feed the loop ie. Loop 1 In (if no other pedal...

Hi there, Some nice gear there, should get some good tones out of your setup. I’d set it up as follows: Wireless-> Polytune-> Morley (I’d only put it here if you use as a wah & volume pedal)-> PX8+ In-> PX8+ SND Loop 1-> Mesa Flux Five In-> Mesa Out-> PX8+ RTN Loop 1-> PX8+ SND Loop 2-> Fender Pugil...

Hi there, Which Soldano SLO model do you have? Does it have the effects loop? Is the effects loop he switchable one? The Control switcher can switch the SLO, via midi.I can receive PC and CC messages via midi and can control either 4 of the switches in any combination. If the SLO has a foot switchab...

Hi there, I’ve not used a different controller other than a GC Pro, but I know if you do use a different controller, the state of every GCX loop must be sent with every preset or they state that they are in will be kept.

Here’s some info for you

viewtopic.php?t=8268

Hi there, You need to make a custom cable out of a 5 pin midi cable and get a 7 pin plug. You need to connect the Pins 1 & 3 to 6 & 7 instead. If you can’t do it, you may be able to find someone to do it for you. The reason you have these faults is probably due to the Plethora x5 using 1 & 3 as midi...

Hi there,
To do this with your Disaster Area DPC 8 EZ Gen 3, you need to add another controller to it, such as their Midi Baby. There isn’t a way to do this, with this being set up in preset mode.
Hope this helps you out.